Start free trial

Home > News, Articles & Multimedia > Blog Entry > Top Security: Custom Table Pads

Top Security: Custom Table Pads

by Fred Taylor (11/16/10).

A good set of custom made table pads can greatly prolong the life of your dining table.

While modern taste in dining room tables, like modern taste in so many subjects today, varies considerably from household to household, the traditional format calls for a flat wooden surface supported by some type of leg or base arrangement.

In medieval times, the surface was just that—a surface—composed of wide boards placed across trestles to create the perfect tabletop. The condition of the wood surface was probably not a subject of much debate, since it most likely didn’t have any finish at all other than old grease stains. But in today’s elegant formal dining room the condition of the tabletop is of primary importance. It becomes something of a showpiece and a great deal of time and money is often devoted to the acquisition and maintenance of that surface.

Over time, though, time that entire thought process can become “inconvenient.” After all, we are talking about a flat piece of wood of a size not normally found in nature. And since it is wood, it tends to be softer than most other horizontal surfaces in the house, such as counter tops. So now not only is the table top made of a large assemblage of a soft material, it is situated slightly below waist height, just the right place to accumulate books, mail, the occasional umbrella and a great many hand prints. And if your house is like my last house, the dining room is situated right in the middle of the main traffic pattern so EVERYBODY has to walk by it several times a day. Not much I could do about that, so I had to develop a protective system that would preserve the beauty of the tabletop and still allow my children the opportunity to achieve adulthood.

The first line of defense was a loosely woven, solid cotton tablecloth that easily hung down to chair seat level. That was topped by a heavy, hand-crocheted lace cloth that, while attractive, also helped deflect minor blows from dropped or thrown articles. Then the six chairs were arrayed around the table with each one slightly separated from the table by about three inches. This helped increase the buffer zone around the table.

Finally, to enhance the sense of protected territory around the dining area we purchased a large Oriental rug to put in the area that became a “no walk” zone for kids and pets—well, for the kids anyway. The pets continued to what they had always done. By removing the tablecloths once a month or so to let the table air out, this primitive defensive strategy worked well—as long as we didn’t actually sit down to eat at the table.

But sooner or later some important event would require the preparation of a lot of things we didn’t ordinarily consume, to be served on china we never used and was placed on the table where we never ate. We learned very quickly that the finish on older furniture is not as sturdy as advertised. Our original dining set was from the late 1930s and, while the tabletop looked nice and clean and shiny, we found out it was just for looks. Forget about hot dishes or cold glasses. Everything seemed to make the table turn white and some things made the finish sticky.

We then embarked a trial-and-error period of auditioning protective surfaces for the tabletop. Since we decided the table shouldn’t be wet, we started with a plastic sheet. On top of that we added the cotton tablecloth, topped off with individual plastic placemats at each setting. Good start but less than great long-term results. It seems that older finishes (and some newer ones, as well) and certain types of plastic and vinyl have an affinity for each other. In other words, the tabletop finish started to grow into the plastic sheet during the rainy season. We saw the beginning of a disaster in the works. Not only that, but the sheet and table cloth had not protected the surface from the normal dinnertime trauma of heavy serving platters or extreme heat.

Arriving at the conclusion that professional advice was probably cheaper than having the table refinished, we asked for help. The answer was so simple and so obvious we were embarrassed that we hadn’t thought of it. The answer, of course, was table pads. But not just any old table pads. I had seen the old, thin, moldy green pads in antique stores and they held no appeal for me. And where would we find some to exactly fit our old table?

Turns out that solution was equally simple. Have new ones made. The representative of one of the national brands came our house, measured the table, made tracings of the corners, let us pick out the colors, took a small deposit and off he went. Two weeks later our custom table pads arrived.

The new pads were more than a half-inch thick with a waterproof vinyl top surface, a fiberboard core, a soft slip-resistant super-suede bottom surface and an aluminum heat shield sandwiched in the middle. Each half of the table had a separate pad, and each leaf did too. The real trick was that there were catches on the edges of each section so the pads all locked together and stayed in place. Did we spend a lot of money? It seemed like it at the time, but as the years wore on the investment paid off. The just-under $200 we spent for near top of the line pads probably came right back to us in the form of a higher resale price for our set when we upgraded. The “new” dining table was a late 18th century Georgian pedestal table, and you know who we called first when it arrived at the front door.

Good-quality, custom-made table pads are among the best furniture investments you can make. Don’t shortchange yourself trying to make do with sheets, blankets, quilts, mattress pads and cheap table pads. Spring for the good stuff one time and be done with it.

Fred Taylor is a antique furniture Worthologist who specializes in American furniture from the Late Classicism period (1830-1850).

——————————–

Send your comments, questions and pictures to me at PO Box 215, Crystal River, FL 34423 or info@furnituredetective.com.

Visit Fred’s website at www.furnituredetective.com. His book “How To Be A Furniture Detective” is now available for $18.95 plus $3 shipping. Send check or money order for $21.95 to Fred Taylor, PO Box 215, Crystal River, FL 34423.

Fred and Gail Taylor’s DVD, “Identification of Older & Antique Furniture,” ($17 + $3 S&H) and a bound compilation of the first 60 columns of “Common Sense Antiques,” by Fred Taylor ($25 + $3 S&H) are also available at the same address. For more information call 800-387-6377, fax 352-563-2916, or e-mail info@furnituredetective.com.

WorthPoint—Discover Your Hidden Wealth

One Response to “Top Security: Custom Table Pads”

  1. TablePads says:

    Ohio Table Pad Company has manufacturer patterns on file. If your table’s manufacturer is not listed, customers can have a tracing kit sent to their home where they can trace the corners of their table and Ohio Table Pad Company can make a new table pad that will fit their table.

Want a picture icon with your comment? Sign up with Gravatar to get one, or connect with your Facebook or Twitter account.

Looking for even more discussion? Check out the WorthPoint Forums.

Leave a Reply

Connect with Facebook