GREAT Crown Macro Tech MA 3600 VZ Amplifier Power Amp

Pricing & History

Sold for
Start Free Trial or Sign In to see what it's worth.
Sold Date
Source eBay

Good Condition Crown Macrotech 3600VZ Power Amplifier Good Condition Crown Macrotech 3600VZ Power Amplifier This listing is for a Crown Macrotech 3600 VZ Power amplifier that belonged to one of our customers who no longer needs it anymore. This amplifier is definitely used, and has some wear, but it's been tested and works PERFECTLY! Remember this is a NO RESERVE AUCTION! As you can see from the pictures, it's still in great condition! Good luck bidding! RETAIL PRICE: $3359.00MA-3600VZ Specifications These specifications apply to 120 VAC units in stereo mode with 8 ohm loads and an input sensitivity of 26dB unless otherwise specified.120 VAC, 60 Hz Units: These units are equipped with transformers rated for 120 VAC, 60 Hz power.International Units: These units are equipped with transformers for either 100 VAC, 50/60 Hz, or 230 VAC, 50/60 Hz power. Power Output Power: The following are guaranteed minimums for standard 1-kHz power from 120 VAC, 60 Hz North American units. Maximum average watts per channel (unless in Mono mode) at 1 kHz with 0.1% or less THD. Stereo mode with both channels driven:1800 watts into 2 ohms.1565 watts into 4 ohms.1120 watts into 8 ohms.Bridge-Mono mode:3505 watts into 4 ohms.3140 watts into 8 ohms.Parallel-Mono mode:3555 watts into 1 ohm.3190 watts into 2 ohms.Load Impedance: Rated for 16, 8, 4, and 2 ohm use only. Safe with all types of loads, even reactive ones.AC Power Requirements: 100 VAC, 50/60 Hz; 120 VAC, 50/60 Hz; and 230 VAC, 50/60 Hz units are available. 230 VAC, 50/60 Hz units can be used with 220 and 240 VAC. All versions draw 90 watts or less at idle. 100 and 120 VAC units can draw up to 30 amps of current; 230 VAC units can draw up to 15 amps.Performance Frequency Response: 0.1 dB from 20 Hz to 20 kHz at 1 watt.Phase Response: 10 from 10 Hz to 20 kHz at 1 watt.Signal-to-Noise Ratio: Greater than 105 dB below rated output (20 Hz to 20 kHz, A-weighted); 100 dB below rated output (20 Hz to 20 kHz, no weighting).Harmonic Distortion (THD): At rated output, less than 0.05% from 20 Hz to 1 kHz increasing linearly to less than 0.1% at 20 kHz.IM Distortion (IMD): Less than 0.05% from 368 milliwatts to full rated output.Damping Factor: Greater than 1,000 from 10 Hz to 400 Hz.Slew Rate: Greater than 30 volts per microsecond.Voltage Gain: (At maximum output) 20:1 6% or 26 dB 0.25 dB at +26 dB gain setting, and 124.6:1 6% or 41.9 dB 1.0 dB at 0.775 volt sensitivity. Controls Enable: A front panel push button used to turn the amplifier on and off.Level: A 31-position detented rotary attenuator for each channel located on the front panel used to control the output level.Stereo/Mono: A three-position back panel switch used to select Stereo, Bridge-Mono or Parallel-Mono operation.Sensitivity: A three-position switch located inside the PIP compartment used to select one of three input sensitivities for both channels: 0.775 volts or 1.4 volts for standard 1 kHz power or a voltage gain of 26 dB.Input Ground Lift: A two position back panel switch used to isolate the phone jack signal grounds from the chassis (AC) ground.Reset: A back panel button for each channel used to reset the corresponding power supply. 100 and 120 VAC units have 15 amp circuit breakers. 230 VAC units have 7.5 amp circuit breakers. Indicators Enable: This amber indicator is on when the amplifier is switched on to show that the low voltage power supply is operating.Signal / IOC: Two green indicators flash with medium intensity in sync with the amplifiers outputs to show signal presence. In the unlikely event the output waveform differs from that of the input by 0.05% or more, they flash brightly to indicate distortion. As sensitive distortion indicators they provide proof of performance. Note: It is normal for the Channel 2 IOC indicator to remain on in Parallel-Mo... read more

Items in the Price Guide are obtained exclusively from licensors and partners solely for our members’ research needs.

Flag item for content or copyright

If this item contains incorrect or inappropriate information please contact us here to flag it for review.

If you are the originator/copyright holder of this photo/item and would prefer it be excluded from our community, contact us here for removal.