Knife Making Blank "S" Series Blade Hammer finish Skinner Blade Scf7 B3

the "Raptor"

Hammer Forged version - Limited

Version A

Offered is a great:

"Raptor" Skinner knife blank for knife makers and hobbyists. I use these alot in knives I make. Very efficient for vivisection. It's sharp, perfect for the hand with finger hole for control, thumb grove and a serrated edge on top for cutting sinew.

They are made 9CR14 Steel which keeps an edge and stainless as well. This is a higher grade steel then most. 6" over all length. Blade 2 1/2". Hammered finish and sharpened. 1/8" Thick. 2 - 1/8" Pin holes. This is an example with walnut handles. Very tough knife and very popular out west with Elk handles.

Our S series knives we design and fabricate. We have tested these on several levels one is reselling. If your a knife maker our blades will make you money.

Business Opportunity and Profitability

We have hundreds of small businesses putting custom handles and reselling our blades and making a good income. I'm often asked where the best place to resell our finished blades is. I was in Alaska recently and two vendors at a local craft show had our blades on display as well as a local merchant. Our blades are well recognized worldwide and highly sought after; The local crafter makes his own niche with our blades. Surprisingly Gun and Knife shows are not the #1 venue but
... read more